The new approach of the production technique of discontinuous Cu-C composite

Authors

DOI:

https://doi.org/10.18690/analipazu.2.1.32-38.2012

Keywords:

Cu-C composite, sintering, internal carbonisation, microstructure

Abstract

The samples of the Cu-C composite were produced by two different techniques: (i) the sintering of powders, and (ii) the internal carbonisation of rapidly solidified pure copper. The aim of the present research was to produce a discontinuous Cu-C composite with the submicron dispersion of graphite particles. The results of our microstructural investigation show that the use of the mechanical alloying and sintering of consolidated powders is an inappropriate way to achieve a submicron dispersion of the graphite particles. On the other hand, the combination of rapid solidification and internal carbonisation was found to be an efficient technique to obtain the requested microstructure.

Author Biographies

  • Rebeka Rudolf, University of Maribor, Faculty of Mechanical Engineering / Slovenia and Zlatarna Celje d.d., Celje / Slovenia., or, Faculty of Mechanical Engineering / Slovenia and Zlatarna Celje d.d., Celje / Slovenia.

    Celje, Maribor, Slovenia. E-mail: rebeka.rudolf@uni-mb.si

  • Ivan Anžel, University of Maribor, Faculty of Mechanical Engineering / Slovenia and Zlatarna Celje d.d., Celje / Slovenia., University of Maribor, Faculty of Mechanical Engineering / Slovenia and Zlatarna Celje d.d., Celje / Slovenia.

    Celje, Maribor, Slovenia. E-mail: rebeka.rudolf@uni-mb.si

Downloads

Published

17.05.2022

Issue

Vol. 2 No. 1 (2012): ANALI PAZU

Section

Prispevki

How to Cite

Rudolf, R., & Anžel, I. (2022). The new approach of the production technique of discontinuous Cu-C composite. Anali PAZU, 2(1), 32-38. https://doi.org/10.18690/analipazu.2.1.32-38.2012

Most read articles by the same author(s)

1 2 > >>